2000 monte carlo radio installation




















Please verify all wire colors and diagrams before applying any information. The aftermarket radio will not fade, however it will still continue to balance. The factory amplifier must be retained and working in order for the C2A-GM24 to work properly. Turning on rear entertainment controls if equipped will make rear outputs of interface play second audio source. Location: Headunit. If your vehicle is equipped with a factory CD changer, you must disconnect it in order to be able to install the Interface.

You will lose the use of the factory CD changer to gain use of your iPod. These devices must be disconnected during the installation and will no longer function. You will lose the use of these devices to gain use of your iPod. Note: Just like factory stereo system, the warning chimes will play through front left RCA output of interface. Turning on rear entertainment controls will make rear outputs of interface play second audio source. All Models with air bag, without heater controls.

All Models with 24 pin connector. Except SUV's and Trucks. Headunits currently not supported: All Delphi XM products. Radio must have R. S and a have phone symbol on the face of the radio. Vehicle must have OnStar and a have phone symbol on the face of the radio. Requires MOT Harness sold separately. Does not control factory alarm. Self learning, no additional programming required. Self learning, no additional programming required, no key required. Good luck. My car has an amp in the back. Answer asap please and Ty.

Dessaray, it sounds like there may be some loose connections somewhere. Double check that all your wiring is solid especially the ground wire.

Good luck with your radio troubleshooting. Left buttons work fine, right do not, radio lights up, all buttons function but no sound,. Your email address will not be published. Leave a Reply Cancel reply Your email address will not be published. Follow Us. Copyright by ModifiedLife.



0コメント

  • 1000 / 1000